High rings for Mm410B

R.W. Parker

R.W. Parker

Well-known member
Found these the other day. Not period, but the 1.300 and 1.500-inch heights will allow the mounting of a modern 1-inch or 30mm tube optic on the 29mm round receiver. And they don't look bad, either.

www.ebay.com

Scope Rings - 11mm and 3/8" Dovetail fit Anschutz , CZ 452 455 457, 1" & 30mm | eBay

Ideal for Anschutz, CZ, and Styer Zephyr Rifles. I installed them on my anschutz 1813 (54 action). 11mm dovetail rings are Precisely machined (see note below) to fit 11mm dovetail rifles. 3/8" dovetail rings are precisely machined to fit 3/8" (see note below) dovetail rifles.
www.ebay.com
 
I'm not so sure those would fit a Mauser Mm410B.

The Mauser has a rounded receiver top, while the CZ's have a flat top. The Anschutz 1710 might work?

I know the person that makes these, I can ask and confirm.
 
I slid one on my 410B and, although the clearance at the crest of the receiver is pretty close, they appear to be fine.
 
Yeah, they're fine. Plenty of clearance between the mount and receiver crest, and the 1.50-inch height allows the bolt handle to clear the chunky magnification ring on this Optika5 2-10x42 PA.

The 1.30 height would probably be okay with a sight having a slimmer exterior profile.

1720465522387.jpeg
 
I expected more of a chin-weld actually, but it isn't bad at all. Probably not much worse than AKAH mounts.

Ever see the sight height on some of those metallic silhouette rigs?
 
A couple years back, when I was looking for a set of rings to clear the round-top receiver on a Walther Sportmodell V, discovered a guy in England (me thinks) whom made adapter blocs for this purpose...
 
You must log in or register to reply here.
Back
Top